DZUS Fasteners???

[fpzx10]

Can someone post a pic or detailed drawing of these things? I swear the instructions were drawn by my four year old.

[Rider]

http://www.racebolts.com/images/Webpics/dzuscompwithrec.gif

[Trip]

did you get rivet type? If so, throw them in the trash and buy the clip ons.

[fpzx10]

http://www.racebolts.com/images/Webpics/dzuscompwithrec.gif

:wtfru:

I meant installed

[Trip]

:wtfru:

I meant installed

rivet or clip on?

[fpzx10]

Clip on

[Trip]

Just slide the clip on to the inside portion, stick the penis end through the outside portion and then into the clip on portion and turn a 1/4 of a turn. You don't have to use the washers, it will stay.

[Rider]

:wtfru:

I meant installed

http://home.twcny.rr.com/zzr/dzus_fasteners_small.jpg

Slide the clip over the existing bolt hole. Mount your plastic, slip the fastener through the plastics into the clip, turn fastener. You're all set.

[fpzx10]

Thanks guys. It was the washers in the drawing that was throwing me off :dthumb:

[Trip]

Thanks guys. It was the washers in the drawing that was throwing me off :dthumb:

they go on the penis. One you put on right from the start, slide it through the outside part and then put the second washer on to hold the penis part to the fairing so you don't lose it. I just leave em off because they are more of a pain in the ass than helpful.

[azoomm]

Thanks guys. It was the washers in the drawing that was throwing me off :dthumb:

No washers used.

Just slide the clip on.

Bad fuzzy picture, but can you see it??