Two Wheel Fix - View Single Post

NONE_too_SOFT · 03-29-2009, 01:27 AM

I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all.

so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back.

Any ideas?

03-29-2009, 01:27 AM	#1
NONE_too_SOFT Chopstix / \ Join Date: Feb 2008 Location: Akron OH Moto: 03 CBR RR Posts: 5,350	Bar ends? I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all. so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back. Any ideas?