Both Blinkers blink when i turn on a turn signal

Kerry_129 · 02-21-2011, 11:27 PM

Those 'load resistors' in addition to whatever is in there already might drop voltage TOO much & dim the ones you do want flashing.

Edit: Those are fairly low resistance/high-wattage & intended to be wired in parallel (between the hot & ground), vs. in series (inline, like the resistor(s) already in the LED circuit which I'm suggesting to increase). They're generally used to slow down the fast-flash, but will also maybe be the simplest way to correct your issue without monkeying much with the existing wiring or trying to figure out resistance values.

02-21-2011, 11:27 PM	#24
Kerry_129 Semi-reformed Squid Join Date: Nov 2008 Posts: 531	Those 'load resistors' in addition to whatever is in there already might drop voltage TOO much & dim the ones you do want flashing. Edit: Those are fairly low resistance/high-wattage & intended to be wired in parallel (between the hot & ground), vs. in series (inline, like the resistor(s) already in the LED circuit which I'm suggesting to increase). They're generally used to slow down the fast-flash, but will also maybe be the simplest way to correct your issue without monkeying much with the existing wiring or trying to figure out resistance values. Last edited by Kerry_129; 02-21-2011 at 11:40 PM..