1971 Honda CL70 restoration

Rangerscott · 01-28-2011, 02:07 AM

New pistons with rings

Luckly the piston pin is a floater.

Bottom paper gasket with rubber oil seal.

Cleaned up cylinder. Also installed a new idle wheel inside it.

Head gasket with two rubber oil seals

Head is nice an clean.

Everything lining up well

Torque down the head and now installing new cam chain.

Putting back clutch cover.

Right engine cover all clean and ready to go on.

and plate

01-28-2011, 02:07 AM	#8
Rangerscott Viff6N Mutated Warrior Join Date: Mar 2009 Location: Texas Moto: '01 Honda VFR 800 & '09 ER-6N Posts: 8,704	New pistons with rings Luckly the piston pin is a floater. Bottom paper gasket with rubber oil seal. Cleaned up cylinder. Also installed a new idle wheel inside it. Head gasket with two rubber oil seals Head is nice an clean. Everything lining up well Torque down the head and now installing new cam chain. Putting back clutch cover. Right engine cover all clean and ready to go on. and plate