|
08-26-2013, 07:47 PM | #1 |
Movie Star
Join Date: Feb 2011
Location: Kingsport, TN.
Moto: KLR650
Posts: 682
|
[QUOTE=Papa_Complex;531554]I had originally thought about using a variable speed router but after checking the proper cutting speeds needed, I chucked that idea. Instead I'm using a keyless chuck hand drill in a homemade clamp, with a 0.008" thick, 1.75" diameter steel jeweler's saw blade.
When cutting aluminum wire I'm running somewhere around 400 rpm but I don't have a laser gauge, so that's only an estimate. I control the speed by plugging the drill into a router speed control box. QUOTE] Ah! I didn't realize you were using aluminum! I was thinking you were using steel and figured you'd need the power of a router to cut that quick. |
08-26-2013, 08:15 PM | #2 |
Nomadic Tribesman
Join Date: Nov 2008
Location: Brampton, Canada
Moto: '09 ER-6n
Posts: 11,150
|
I can run much higher speeds than I do when cutting aluminum but the funny thing is that the tougher the metal, the lower the speed that you cut it with. The routers that I checked, including my own, were up in the 10,000 rpm range. Aluminum should be cut at no more than about 1,000 rpm with the size of blade I use. I also routinely cut brass, which should be cut at around 200 rpm. Mild steel is about the same as brass. Mid strength Ti or stainless steel is around 100 rpm, but I haven't tried them yet. no idea if my current rig can handle it.
__________________
"Everything's better with pirates." - Lodge, "Dorkness Rising" http://www.morallyambiguous.net/ |
08-26-2013, 08:49 PM | #3 |
Movie Star
Join Date: Feb 2011
Location: Kingsport, TN.
Moto: KLR650
Posts: 682
|
Those router speed controls come in handy don't they! I have one I use for a lot of different things. I've even used it on my hand-mixer when the lowest speed was too fast for the recipe!
|
Bookmarks |
|
|